Total Pageviews

Monday, 29 August 2011

This is a Very Common Fault

Richard,

Thanks to your very detailed article I got my wife's 307 Zest well fixed. It all stsrted with speed 2 not working shortly after the car was bought but she never did anything about it. Eventually started to become intermittent on all speeds and during -15 degrees January past it totally stopped.

We were almost killed coming home in -17 degrees C when it failed after we came out from the Smokie concert at the Waterfront Theatre in Belfast, and we had to drive the car 25 miles in 2 feet deep snow on the M2 between Belfast and Antrim ungritted and both the inside and outside of the windscreen iced heavily and I had to use an ice scraper with a poor end which was only clearing a 5 mm wide line for me to see through, it was really scary as we then hit freezing fog and a heavy blizzard and I could see prectically nothing.

Anyway I have since stripped out the fan and removed the resistor bank in the ducting which had very heavy burning around Pin 1, I scraped out the charred surround of pin 1 on the resistor unit and repaired with new Epoxy, the plug connector which pushes in to the resistor was completely disintegrated around the Pin 1 end and the main wire coming out of Pin 1 which feeds direct to the blower fan was burned away totally for about 30mm and very badly hardened for about 50mm.

I cut the wire back and renewed with a new piece of cable and a new push on blue crimp, I then used a junior hacksaw to cut away the charred remains of the receptacle where pin 1 had been and put the new wire on pin 1 and then pushed home the remaining (now 5 pin connector) all is working perfectly now and the cost was a few cuts on my hands, as access is extremely tight and actually I had to remove the damaged connector on the drivers side to get enough length to allow me to cut away the charred pin 1 receptacle end of the connector.

This is to me a design fault on the Peugeots and I think potentially a fire risk, and is caused by the Pin 1 connector in the receptacle not being capable of carrying the Full Load Current for an extended period of time when it starts to burn and blacken and soften the copper of the receptacle. Peugeot should have recalled all cars with this set up and replaced the 59CLM free of charge with a new loom and connector man enough for the job.

I have a photo of the removed Pin 1 connector if you wish to see it I will send you a pic, many thanks for an excellent article which has saved a lot of people a lot of money if they took your advice.

                                                          Paul
 

Saturday, 27 August 2011

http://wbs.electricjungle.org/

http://wbs.electricjungle.org/

This is my Personal Homepage

Loads of DIY Examples



Single Story Extension 35 Square meters in Size ( Annex ) Large DIY Content

 This page is dedicated to the detailed construction of a single story extension of 35 Square Meters in Size.

Commence On 24/07/2010



I will add pictures and cost information of this build. If you have any questions or would like me to add any specific information please contact me with you request.

I will cover all aspects of this build from footings to signoff by the buildings inspector.

I hope you find some of the information useful on this page.



 
 Full Details can be found on my personal web page below.


ABS Fault DIY Fix Peugeot 307 HDI 2003 110 BHP

Hi Everyone, Sorry for the lack of posts lately i have been building an extension on house so have been very busy.

Had a fault on ABS system on my 307 HDI over the last few weeks so i have documented the actions and experiences i have had during the repair process.

I have also uploaded some pictures for visual reference

The information is all stored on my personal homepage, some of the detail may help you if you’re having problems with your ABS system.

http://wbs.electricjungle.org/peugeot_307_hdi.html



Best Regards